Robot Repair Shop
The arm of the robots used by Explosive Ordnance Disposal teams consists of a circuit board with instructions attached directly to the main circuit board. When a system is damaged, technicians rebuild the robots from the surviving parts, replacing damaged areas with new or refurbished pieces. Occasionally, the technicians will re-solder and repair the circuit boards themselves.

BAGHDAD - One arm and a visceral cavity, wide open with its contents scattered about, is the cost of saving Soldiers' lives. But the brain is intact.

Despite the destruction, the remotely operated vehicle can be rebuilt and salvaged by Camp Victory's Joint Robotics Repair Facility.

This is an all-volunteer workshop that keeps warfighters safe by ensuring the first line of contact with insurgents and their devices is not human.

"The robotics aspect here removes the (troops) from the dangerous situations they don't need to be in the proximity of," Lance Cpl. Aaron Bridgewater, an incoming technician in training at JRRF, said.

Most of the robots maintained by the facility are used as preventive measures against improvised explosive devices.

"(Explosive ordnance disposal detachments) have a rough job," said Marine Chief Warrant Officer Luis Viera, JRRF executive officer, 65th Regional Readiness Command. "The enemy has chosen the place and time. What separates them from the enemy are these little guys."

One of the robots Viera is referring to is the Talon III B, a smart robot that can tell the operator the grade angle it is maneuvering at and the position of its arm. It also comes with four cameras, night vision, a microphone with which to listen to the environment, and a bounty on its head.

"A lot of times they send this guy down and the insurgents are waiting," Viera said. "They shoot at it because they know it is effective."

The Talon III B and other robots are used to visually examine and sometimes detonate improvised explosive devices while keeping ground forces a safe distance and, mostly, out of harms way.

When the robots are damaged and can no longer perform their duties, they are taken to one the forward repair facilities or brought to the workshop.

"We make it a point that no one leaves this facility without an actual working robot," said Chuck Burns, JRRF shop manager.

Viera added that the facility maintains a fourhour standard for repairs so units do not have to risk lives performing their jobs without one.

Despite the quick turnaround time, operators who bring in their robots do not always get the same one back, but no robot is too damaged to be repaired.

"When we repair a robot, we also repair their [damaged] parts to reuse, if we can," said Rick Ramsey, JRRF technician.

"Occasionally one of the boards will be cracked and we'll go down to that level too."

While some robots are too damaged to be rebuilt, they are few and far between.

"Some of the robots are completely destroyed," Burns said. "Now, we have more robots and more parts in theater. A year and a half ago, we didn't have nearly as many resources. As long as we have a serial plate we can rebuild a robot. We can rebuild from just about anything (and) create a robot from mix and match parts."

Since its inception three years ago, the program has increased exponentially in use and size.

"Three years ago there was a requirement for EOD robots to visually inspect (IEDs)," said Maj. Stephen Mufuka, facility manager. "The initial requirement was for 162 systems, now we have more than 4,000."

The end mission saving lives is the primary motivator for the success of the program.

"Before, EOD had to visually inspect an IED, now they send a robot to do that," Mufuka said. "If a robot gets blown up, you can replace it. If a robot arm gets blown off, you can replace it, but you cannot replace a human."

Page last updated Tue June 5th, 2007 at 09:57